Fire hose laying and rolling requirements

The connection method of the fire hose, including the laying and winding method of the hose, let’s take a look at the method and specific requirements of laying the hose with one hand.

1. Hold the rolled hose with your right hand, pinch the outermost two circles with your thumb and forefinger (joint facing forward), and hook the third and fourth circles of hose with the remaining three fingers.

2. With the left foot in front and the right foot behind, bend down and swing the hose back and forth (the swing should not be too large), then throw the hose forward, and always pinch the outermost two circles of leather with your thumb and index finger when throwing out the hose Dragon, straighten the other three fingers, and the hose will roll forward.

3. After the hose is thrown, it should be in a straight line and fully unfolded, and the left and right range of deviation from the front is ≤1 meter. When the hose is thrown, the metal connector must not fall off the ground.

Method and requirements for two-person winding hose

1. After the hose is used, pour out the remaining water in the hose.

2. Assist the coiling students to fold the hose in half to form a double layer. The lower layer of hose is about 30 cm longer than the upper layer of hose. Step on the part of the hose near the joint with your feet, and the coiling student will fold the two layers of hose at the other end. Shake, straighten, lay flat and stack up and start to bend down to wind up the belt, assist the wind up students to go to about 2 meters in front of the wind up students, stand with both feet on the water belt left and right and straddle the water belt, bend over and hold the upper layer of water with both hands The two layers of water hoses are stacked neatly, which is convenient for the students to take up the belt. As the students take the belt forward, assist the students to step back slowly until the take-up is completed.